Effect of Electrolytic Solution on Corrosion Behavior and Mechanical Properties of a Coated AZ31 Magnesium Alloy Via Plasma Electrolytic Oxidation Process

Mehdizadeh, Yasin; allahkaram, Saeed Reza; H.Mohammad-Ebrahimi, Mohammad; Shamsarjmand, Majid

doi:10.22068/ijmse.3694

IN PRESS Back to the articles list | Back to browse issues page

‎ 10.22068/ijmse.3694

Effect of Electrolytic Solution on Corrosion Behavior and Mechanical Properties of a Coated AZ31 Magnesium Alloy Via Plasma Electrolytic Oxidation Process

Yasin Mehdizadeh

, Saeed Reza Allahkaram

, Mohammad H.Mohammad-Ebrahimi

, Majid Shamsarjmand

Abstract: (343 Views)

The present work deals with the corrosion behavior and mechanical properties of a coted AZ31 magnesium alloy through plasma electrolyte oxidation (PEO) coating process in different alkaline electrolytes based on sodium silicate (Si-coating), sodium polyphosphate (P-coating) and sodium aluminate (Al-coating). The scanning electron microscopy (SEM) equipped with the energy dispersive x-ray spectroscopy (EDX) plus x-ray diffraction were recruited to investigate the morphology, chemical composition, and phase structure of coatings, respectively. Microscopic scrutiny revealed that the coating in the phosphate electrolyte was twice as thick and the relative porosity percentage was higher than those formed in the other electrolytes. The phase analysis indicated that the MgO was present as the prevailing phase in the Al-coating and P-coating. However, the dominant phase in the Si-coating was Mg₂SiO₄. Electrochemical testing was examined in a solution containing 3.5.wt% sodium chloride, showing improvements in corrosion resistance of coated alloys. These investigations confirmed that the corrosion resistance of Si-coating was dramatically higher than others which could be attributed to the presence of the dense and stable Mg₂SiO₄ phase as well as its relatively low porosity. According to the results of tensile tests, the coated samples had lower tensile strength and elongation than the uncoated one. The tensile strength and elongation diminished upon changing the electrolyte from Al-coating to P-coating, while the yield strength was almost similar. Further analyses indicated that the drop of tensile strength and elongation could be attributed to the presence of cracks and pores in the brittle ceramic PEO coating as stress concentration regions during deformation. Those areas are created due to thermal stress during the coating process and deformation in the elastic stage.

Keywords: Mechanical properties, AZ31 Magnesium alloy, plasma electrolytic oxidation (PEO), corrosion behavior